Click or drag to resize

DinMotor Properties

The DinMotor type exposes the following members.

Properties
 NameDescription
Public propertyDeviceThisMotorIsOn Returns the device that the MotorBase is attached to.
(Inherited from MotorBase)
Public propertyIsLastDirectionCloseFeedback Property to indicate that the current direction of movement is Close (momentary, full or jog).

The BaseEvent event will trigger with LastDirectionIsCloseEventId.

Public propertyIsLastDirectionOpenFeedback Property to indicate that the current direction of movement is Open (momentary, full or jog).

The BaseEvent event will trigger with LastDirectionIsOpenEventId.

Public propertyIsMovingFeedback Property to indicate that the motor has received an Open or Close command (momentary, full or jog).

The BaseEvent event will trigger with IsMovingEventId.

Public propertyMotorState Property to set the Motor State and to get the current Motor State. Stop to be invoked to abort the current operation.
(Overrides MotorBaseMotorState)
Public propertyNumber Number of this Motor.
(Inherited from MotorBase)
Public propertyParameterJogTime Parameter to set the time in milli seconds that the motor will move during a jog open or jog close operation. Value range is from 0.05 seconds to 2 seconds for "ClciMcex". 1 second is represented as 100.
(Inherited from MotorBase)
Public propertyParameterLockoutTime Parameter to set the minimum time that the motor must remain in the stop state before changing directions between open and close. Value range is from 0.2 to 2 seconds for "ClciMcex". 1 second is represented as 100.
(Inherited from MotorBase)
Public propertyParameterMaximumTime Parameter to set the maximum time in milli seconds that the motor can move in the open or close direction. Value range is from 1 to 360 seconds for "ClciMcex". 1 second is represented as 10.
(Inherited from MotorBase)
Public propertyParameterOverride Parameter to specify the corresponding motor state to recall in the event the unit enters override. Refer eDinMotorOverride for the valid values. This parameter is not supported by ClciMcexClciMcexMotorController.
Top
See Also