ZummeshNetbridgeLoadShedEnable Property |
Property to enable/disable Load Shedding.
When "true" will enable Load Shedding. When set to "false", Load Shedding is disabled.
This sends a signal to every load controller in the room telling it to go into Load Shedding mode. Basically Load Shedding Mode
is a state where there is an alternate MAXimum value imposed on the dimmers as specified by
LoadShedMaxLevel. For switch
type controllers, it may tell the device that it needs to be off when Load Shedding is enabled.
The minimum firmware version on the device which supports this property is v1.009.0012.
Namespace: Crestron.SimplSharpPro.LightingAssembly: Crestron.SimplSharpPro.Lighting (in Crestron.SimplSharpPro.Lighting.dll) Version: 2.21.121
Syntaxpublic BoolInputSig LoadShedEnable { get; }Property Value
BoolInputSigVersion Information
.NET
Supported in: 6.0
.NET Compact Framework
Supported in: 3.5
See Also