Click or drag to resize

DaliBallast Properties

The DaliBallast type exposes the following members.

Properties
 NameDescription
Public propertyDeviceLoadIsOn Returns the GenericBase device the DaliBallast is on.
Public propertyGroupNumber Property to set the number of the group to which the ballast is added or the group from which the ballast is removed.
Public propertyInGroupFeedback Property to indicate if the DaliBallast is a member or not, of the group set to the GroupNumber property.

The DinDali2SigEventChange event will trigger with InGroupFeedbackEventId.

Read this property value from the event handler when the event is triggered for the event ID InGroupFeedbackEventId after the GroupNumber property is set or read it after a timeout.
Public propertyLampFailureFeedback Property to report lamp failure at the DaliBallast.

The DinDali2SigEventChange event will trigger with LampFailureFeedbackEventId.

Public propertyLevel Property to set the brightness level for the DaliBallast.
Public propertyLevelFeedback Property to report the current brightness level for the DaliBallast.

The DinDali2SigEventChange event will trigger with BallastLevelOutFeedbackEventId.

Public propertyLevelReportingEnable Property to enable the ballast level reporting through LevelFeedback for the DaliBallast. true: Level reporting enabled; false: Level reporting not enabled
Public propertyLower Property to lower the light level of the DaliBallast using the ramp rate defined in the DaliBallast.
Public propertyMissingFeedback Property to indicate that the DaliBallast has failed to report as part of the polling cycle.

The DinDali2SigEventChange event will trigger with MissingFeedbackEventId.

Public propertyNumberDaliBallast number
Public propertyPowerFeedback Property to report the ballast's power consumption in hundredths of watts.

The DinDali2SigEventChange event will trigger with PowerFeedbackEventId.

This property is not supported by ZumNetJBoxDaliLegacy
Public propertyRaise Property to raise the light level of the DaliBallast using the ramp rate defined in the DaliBallast.
Public propertyStatusFeedback Property which is an 8-bit value that reports the status of the DaliBallast. The high-order byte is ignored.

The DinDali2SigEventChange event will trigger with BallastStatusReceivedEventId.

Top
See Also