The IGlsCenOcc type exposes the following members.
Methods| | Name | Description |
|---|
 | AndWhenVacated |
Method to trigger both passive infrared (PIR) OR ultrasonic (US) motion sensors to detect motion to declare initial occupancy, if the room is vacant.
|
 | DisableLedFlash |
Method to disable the red and green feedback LEDs from blinking when motion is detected.
|
 | DisablePassiveInfraredSensor |
Method to disable the passive infrared (PIR) Sensor.
|
 | DisableShortTimeout |
Method to disable the short timeout functionality. See EnableShortTimeout method for description.
|
 | DisableUltrasonicSensorSideA |
Method to disable the ultrasonic (US) Sensor side A. This does NOT enable side B.
|
 | DisableUltrasonicSensorSideB |
Method to disable the ultrasonic (US) Sensor side B. This does not enable side A.
|
 | EnableLedFlash |
Method to enable the red and green feedback LEDs. The red LED turns on as the passive infrared (PIR) sensor detects motion, and the green LED turns on as the ultrasonic (US) sensor detects motion.
|
 | EnablePassiveInfraredSensor |
Method to enable the passive infrared (PIR) Sensor.
|
 | EnableRawStates |
Method to enable "RawOccupancyDetectedFeedback", RawOccupancyDetectedByPassiveInfraredSensorFeedback and RawOccupancyDetectedByUltrasonicSensorFeedback properties.
|
 | EnableShortTimeout |
Method to enable a “walk-through” mode for a shorter timeouts upon periods of minimal occupancy. If the room is occupied for less than 90s, the timeout will revert to 60s.
If the normally programmed timeout is set less than 60s, that timeout will take precedence. This is useful for rooms with normally a long timeout setting, so if the room is
only entered for a short period of time, and occupancy is triggered, the lights do not remain on for a longer period than needed.
Short timeout does not apply if occupancy event was a ""Grace occupancy"" (previous vacancy time is greater than 15 seconds).
|
 | EnableUltrasonicSensorSideA |
Method to enable the ultrasonic (US) Sensor side A. Does NOT disable side B. Side A is the side where the majority of the red LED is shown through the dome.
|
 | EnableUltrasonicSensorSideB |
Method to enable the ultrasonic (US) Sensor side B. This does NOT disable side A. Side B is the side where the majority of the green LED is shown through the dome and is also identified on the back-housing plastic rim.
|
 | ForceOccupied |
Method to force the device to report that the room is occupied even if the passive infrared (PIR) sensor does not detect motion.
VacancyDetectedFeedback sets to false and "OccupancyDetectedFeedback" sets to true.
RawOccupancyDetectedFeedback is set to true when ForceOccupied is called. The sensor will then be in the occupied state for the duration of the set timeout.
|
 | ForceVacant |
Method to force the device to report that the room is vacant even if the passive infrared (PIR) sensor does not detect vacancy.
"OccupancyDetectedFeedback" sets to false and VacancyDetectedFeedback sets to true. Upon forcing vacancy, there is a 5 second delay before the sensor begins re-sensing for motion.
|
 | OrWhenVacated |
Method to trigger either passive infrared (PIR) OR ultrasonic (US) motion sensors to declare initial occupancy and set the sensor to the occupied state, if the room is vacant.
|
Top
See Also