IDmps |
public interface IDmps3OutputMixer
The IDmps3OutputMixer type exposes the following members.
| Name | Description | |
|---|---|---|
| Delay | Sets the delay level. | |
| DelayFeedback | Reports the current delay level. | |
| MaxVolume | Specifies the maximum volume gain, in tenths of a dB. The MinVolume and MaxVolume properties allow endpoints to be set for volume control. Typically, this property would not be used since the minimum volume can be set through the Front Panel Setup Menus or using the DM Tool in Toolbox. | |
| MaxVolumeFeedback | Reports the current maximum volume gain, in tenths of a dB. | |
| MicLevel | Property to set the value of the level for a given microphone on this output. | |
| MicLevelFeedback | Property to read the feedback level for a given microphone on this output. | |
| MicMuteOffFeedback | Property to return the state of the MicMuteOffFeedback for a given microphone on this output | |
| MicMuteOnFeedback | Property to return the state of the MicMuteOnFeedback for a given microphone on this output. | |
| MicPan | Property to set the value of the pan for a given microphone on this output. | |
| MicPanFeedback | Property to read the pan level for a given microphone on this output. | |
| MinVolume | Specifies the minimum volume gain, in tenths of a dB. The MinVolume and MaxVolume properties allow endpoints to be set for volume control. Typically, this property would not be used since the minimum volume can be set through the Front Panel Setup Menus or using the DM Tool in Toolbox. | |
| MinVolumeFeedback | Reports the current minimum volume gain, in tenths of a dB. | |
| MixerBypassedFeedback | Indicates that the routed audio input is in mixer bypass mode. Mixer bypass mode allows advanced audio to pass through the HDMI switch. The DMPS3 mixers only support stereo PCM. On digital outputs, this means that the audio is routed directly from the audio source without passing through the mixer. The microphone mix and audio controls are not available. On analog outputs the selected source audio will be muted. Mixer bypass mode is only controllable via the DMPS Tool. | |
| OutputMixerType | The type of Output Mixer available. See the definition of IOutputMixer interface for more information. | |
| OutputVuFeedback | Reports the VU meter feedback value, when VU feedback is enabled. | |
| StartupVolume | Specifies the startup volume in tenths of a dB. The startup volume is the volume level that will be set when the system is turned on. | |
| StartupVolumeFeedback | Reports the current startup volume in tenths of a dB. |
| Name | Description | |
|---|---|---|
| MicMuteOff | UnMute the given microphone on this output. | |
| MicMuteOn | Mute the given microphone on this output. |
IDmps3OutputMixer outputMixer = output.OutputMixer as IDmps3OutputMixer; if (output != null) { if (outputMixer.OutputMixerType == eOutputMixerType.Dmps3OutputMixerWithMonoAndStereo) { // If it supports Mono/Stereo, toggle it. Dmps3OutputMixerWithMonoAndStereo OutWithMS = (Dmps3OutputMixerWithMonoAndStereo)output; if (OutWithMS.MonoOutputFeedback.BoolValue == true) OutWithMS.StereoOutput(); else OutWithMS.MonoOutput(); } }